Where To Buy Edelbrock
Stainless Hose Ends & Adapters
Full Flow Hose Ends
Full Flow Swivel Hose Ends
ProFlex and ProRace Hose
Nitrous Lines
Twist-Lok Hose
Twist-Lok Hose Ends
PowerFlex Power Steering Hose
PowerFlex Power Steering Hose Ends
Tube Seal Hose Ends
POWERFLEX POWER STEERING HOSE
HOW TO ASSEMBLE POWERFLEX HOSE & HOSE ENDS

Step One: Wrap the hose tightly with electrical tape or racers tape. Hold the hose firmly in a vise without crushing and cut through the tape. Make sure you make a straight cut. Remove the tape slowly and deburr with Teflon® edges Install the socket on the hose and slide it back out of the way. Step Two: Insert the nipple portion of the PowerFlex hose end in a vise. Slip the hose over the nipple using a twisting motion to size the I.D. of thie teflon. Seperate the wire braid from the O.D. of the Teflon® tube with a small screwdriver. Be careful not to crush the Teflon®. Step Three: Push the olive sleeve around the Teflon® and between the braid. This can be done by pushing the olive sleeve against the slide of your workbench or vise. Be sure the Teflon® liner is square to the bottom of the olive. With the nipple in the vise, lube the threads and the nipple portion of the hose end sparingly. Insert the hose over the nipple making sure the olive does not pop off the Teflon® tube. Step Four: Start the socket onto the nipple by hand. Tighten with a wrench until the gap between the nipple and the socket is no more than 1/16". Clean the hose assembly and pressure test before using.
 
Listings in red are new for 2004!
© 2004 Edelbrock Corporation